"You have a great team of hard workers. They had one break of about 20 minutes and would not stop for morning or afternoon tea when I offered."
- Brian and Heather
Ceiling & Underfloor Insulation
Specialising in underfloor and ceiling insulation in the wider North Canterbury region; covering Christchurch suburbs; Rangiora suburbs/Hurunui suburbs/rural location
Our team can normally insulate the ceiling and underfloor of an average home in one day, whereas the average handy man would take approx. up to a week to install, and in most cases wished that they had never started. It is an extremely
dangerous and demanding environment that our team work in. Safety precautions need to be taken very seriously as many challenges are found when working in confined spaces, health hazards, electrical wiring, plumbing etc.
South Island has been placed under a Zone 3 R-value requirements and installation of such must comply with NZS 4246:2006 and
your area local body authority regulations.
So don’t wait - Ring to make a date - So we can insulate!
Waimak Insulation - Phone: 03 313-6175
Imagine how much you could save on your power bills if you kept that heat inside your home! Those two combined alone is a heating loss of nearly 50%. Once installation is up-to-date with current requirements you could not only save that 50% loss but actually have to heat your home less in order to maintain it at the recommended indoor temperature of around 18-20oC.
Heating a house can be very expensive if you are losing most of the heat in your house. The longer you are required to heat your house up, the higher your expenses are.
Installing quality insulation will help solve this problem and save you money. A heatpump can give up to $3.50 worth of heating for every $1 of power. Combined with the right insulation - your cost of heating can go down.
Waimak Insulation offers draught stopping product for your windows and doors.
Waimak Insulation offers LOW flow shower-heads which, help reduce hot water waste but don't lower the shower pressure, while still providing a great shower. By restricting the flow and forcing the water through very small apertures, these shower-heads aerate and increase the velocity of the water, creating a very fine but "wet feeling" spray pattern. These devices can save substantial amounts of both energy and water and also saving half the amount one would normally use.